Data networks often have to be installed in extremely limited spaces. This is particularly critical when connecting the cables to RJ45 connectors and modules that can be assembled in the field: For reliable data transmission, the minimum bending radius of the cable must not be fallen short of, but most connectors and modules on the market are relatively long. The SL series from Telegärtner not only offers transmission values that far exceed the requirements of the standards, connectors and modules are also extremely short, so that there is enough space for correct, trouble-free cable routing.

SL series connectors and modules exceed the requirements of Category 6A for data rates up to and including 10 Gbit/s in both shielded and unshielded versions. Both variants correspond to DIN EN 50173-1:2018-10.

RJ45 module AMJ-SL

• Extremely short overall length of only 32 mm
• Optimised contact design to avoid spark erosion in the area of data transmission
• Extremely mechanical robust zinc die-cast housing with refined surface
• Secure latching thanks to a metal barbed snap-in latch
• One-piece snap-in/snap-out housing
• 4PPoE according to IEEE 802.3bt
• Suitable for 10 Gigabit Ethernet
• GHMT PVP certified
• GHMT Type Approval: certified and IEC and EN 60603-7-51 compliant RJ45 module Cat.6A for applications of ISO/IEC 11801 Parts 1-6 and EN 50173 Parts 1-6 (incl. 10GBase-T, 4PPoE)

The unshielded RJ45 module UMJ-SL

• Extremely short overall length of only 32 mm
• One-piece housing, so no housing components can get lost on-site
• Assembly in less than 90 seconds
• No need to untwist the wire pairs
• Tried-and-tested wire manager for exceptionally quick connecting of the wires
• Fits all Telegärtner AMJ and UMJ patch panels and outlets
• 4PPoE according to IEEE 802.3bt
• Suitable for 10 Gigabit Ethernet
• GHMT Type Approval: certified and IEC and EN 60603-7-51 compliant RJ45 module Cat.6A for applications of ISO/IEC 11801 Parts 1-6 and EN 50173 Parts 1-6 (incl. 10GBase-T, 4PPoE)

RJ45 Stecker MFP8-SL 

• very short installation length of only 44 mm
• fine-graded cable strain relief for cable Ø up to 9 mm
• increased cable strain relief due to small barbs holding the cable sheath
• long release latch Insertion and withdrawal made easy in confined spaces
• pre-assembled protection cap Effective protection of contacts from dirt and damage in transit also whilst cable assembly
• standardised plug interface according to IEC 60603-7-51
• robust zinc die-cast housing hardened and tempered finish for mechanical protection
• 360° shielding Reliable data transmission even with outside electrical interference
• piercing contacts IPC 
• full metal shielding between pairs of wires
• four-chamber wire manager Available with colour code T568A, T568B, PROFINET